Make Narrow Bookcase Design Ideas

Black Narrow Bookcase

Narrow bookcase – The houses are often odd-calibrated or tight spaces where a custom fit nicely shelf. However, it is unlikely to find a standard library that fits precisely in the place of issue. Custom shelves made by a cabinetmaker can be prohibitive. Fortunately, the shelves are relatively easy to build.

With some basic tools and work a weekend, you can point to the narrow bookcase between the wall and the fireplace and proudly say “I built.” Measure the height, width and depth of space. For the purposes of this article, the available space is supposed to be 6 feet, 10 inches wide and 8 inches deep.

Adjust the size of the library to fit your own space. Cut a board into seven shelves 8 1/2 by 8 inches wide. Cut the other two tables at 6 feet tall. Mark two vertical lines on one side of the boards 6 feet 2 inches of the outer edges and extend the entire length of the boards. Marks the first horizontal line at the top of the motherboard. Then mark horizontal lines every 10 inches.

Best Post  Tips to Selecting the Short Bookcase

Wrap a piece of masking tape around the end of the drill bit as a marker indicating a measure of 1/4 inch. Drill a hole at each intersection of the pencil lines, 1/4 inch deep. Do not drill into the line socket on the bottom of the boards. When finished, you should have two parallel columns of peg holes in each board.

Draw a drop of wood glue along the side edges of the bottom shelf. Aligns with the top of the line marked on both sides socket 6 feet. Pre-drill and then secure with three screws on the sides and on the rack. Draw a line of wood glue on the sides of a rack. Align the platform flush with the upper edges of the shelf.

Pre-drill through the sides of the rack and the rack, and then secure it with three screws. Place the shelf in space, and make sure it fits properly. Otherwise, unscrew the top and bottom parts and adjust the sizes before the glue dries. Pull back the space.

Best Post  Rustic Bookcase

Fit the wood to the back of the library with nails. Hammer almost all the way in, and then use the set of nails so they are the heads of the nails flush with the plywood. Replace the bookstore space. Fit the socket cut in the bottom of the shelf with glue and finish nails. Align with existing socket. Lisa wood putty along the recesses and the corresponding paint retouching. Insert the shelf pegs into the holes. Slide the shelves above the pins. Finally, you have narrow bookcase in your home.